DTC    CB-52    No Playable iPod File Exists

DTC    CB-7E    No Playable USB File Exists

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
CB-52
No playable files on the "iPod"
"iPod"
CB-7E
No playable files on the USB device
USB device

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.CHECK USB DEVICE OR "iPod"

  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Check if playable files are present on the USB device or "iPod".

    HINT:
    Refer to System Description for playable files (Click here).

    Result:
    Result
    		Proceed to
    No playable files exist.
    		A
    Playable files exist.
    		B



B
Go to step 2
A

END 

2.REPLACE USB DEVICE OR "iPod"

  1. Turn the power switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the power switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the power switch on (ACC).

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


3.CLEAR DTC

  1. Clear the DTCs (Click here).


NEXT


4.RECHECK FOR DTC

  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU assembly.

    OK:
    No DTCs are output.



NG
REPLACE MULTI-MEDIA INTERFACE ECU ASSEMBLY (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE