NOISE FILTER > INSPECTION

for Preparation Click here



1. INSPECT NOISE FILTER

  1. With the noise filter installed, check that there is no looseness or other abnormalities.

  1. Remove the noise filter.



    E183893E05

  1. Measure the resistance of the noise filter according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 (+B) - 2 (GND)
    		Always
    		10 kΩ or higher
    2 (GND) - 3
    		Always
    		Below 1 Ω

    Text in Illustration 
    *a
    		Noise Filter