PRE-CRASH BRAKE CANCEL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PRE-CRASH BRAKE CANCEL SWITCH ASSEMBLY


    E186380E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 - 2
    		Pressed
    		Below 1 Ω
    Not pressed
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Pre-crash Brake Cancel Switch Assembly)