AIR CONDITIONING SYSTEM > GENERAL



OUTLINE

  1. The automatic air conditioning system uses left and right independent temperature control and neural network control to enhance comfort.


SPECIFICATION

  1. Performance

    Heater
    		Heater Output
    		W
    		5200
    Air Flow Volume
    		 m3/h
    		330
    Power Consumption
    		W
    		205
    Cooler
    		Cooling Capacity
    		W
    		4600
    Air Flow Volume
    		m3/h
    		475
    Power Consumption
    		W
    		250

  2. Ventilation and Heater Core

    Heater Radiator Unit Sub-assembly
    		Type
    		Straight Flow Aluminum (SFA)-II
    Size W x H x L
    		mm (in.)
    		201.5 x 150 x 27 (7.9 x 5.9 x 1.1)
    Fin Pitch
    		mm (in.)
    		1.8 (0.07)
    Blower with Fan Motor Assembly
    		Motor Type
    		Brushless Step-IV
    Fan Type
    		Semi Sirocco
    Fan Size (Dia. x H)
    		mm (in.)
    		155 x 65 (6.1 x 2.6)

  3. Air Conditioning

    Cooler Condenser Assembly
    		Type
    		Multi-Flow (MF)-IV
    Size W x H x L
    		mm (in.)
    		636 x 293.4 x 22 (25.0 x 11.6 x 0.9)*1
    636 x 280.6 x 22 (25.0 x 11.0 x 0.9)*2
    Fin Pitch
    		mm (in.)
    		2.7 (0.11)
    Compressor with Motor Assembly
    		Type
    		ES27
    Oil Volume
    		cc
    		120 to 135
    No. 1 Cooler Evaporator Sub-assembly
    		Type
    		Revolutionary Super-slim Structure (RS)
    Size W x H x L
    		mm (in.)
    		226.1 x 241 x 38 (8.9 x 9.5 x 1.5)
    Fin Pitch
    		mm (in.)
    		3.0 (0.12)
    Refrigerant
    		Type
    		HFC 134a
    Charge Volume
    		g
    		440 to 500
    Clean Air Filter
    		Pollen Removal Type
    *1: Except G.C.C. Countries models
    *2: G.C.C. Countries models


MAIN FEATURES

  1. The air conditioning system has the following features:

    High Performance
    1. Neural network control is used so passengers can finely control the air conditioning for maximum comfort.
    2. Micro dust and pollen filter mode control is used to remove pollen in the area around the upper part of the bodies of the driver and front passenger.
    3. The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control.
    Lightweight
    		A bus connector with a built-in IC is used in a lightweight wire harness design to allow a reduced number of wires. The use of this connector means that pulse pattern type servo motors are used.
    Compact
    		A blower motor with a built-in blower motor controller is used to achieve compact construction.
    Others
    		The following parts are used to ensure high performance while realizing a compact and lightweight construction.
    1. ES27 type electric inverter compressor
    2. Electric heater water pump
    3. Semi-center location air conditioning unit
    4. Revolutionary super-slim Structure (RS) evaporator
    5. Straight Flow Aluminum (SFA)-II heater radiator sub-assembly
    6. Multi-Flow (MF)-IV sub-cool condenser