Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here



1. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING


    B270427E01

  1. Put protective tape around the center roof drip side finish moulding.
    Text in Illustration 
    *1
    		Protective Tape



    B270425

  1. Using a moulding remover, disengage the 2 clips and remove the center roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips.
    2. If any clip is damaged or falls out, replace it with a new one.