Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID

BRAKE FLUID > ON-VEHICLE INSPECTION

for Preparation Click here


NOTICE:
If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decreased efficiency.

HINT:
If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brake pad wear. After repair or replacement, adjust the brake fluid level in the reservoir as specified below.



1. INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (for Using the intelligent tester)

  1. Connect the intelligent tester to the DLC3 with the power switch off.

  1. Check that park (P) is selected and the parking brake is applied, and turn the power switch on (IG).

  1. Turn the intelligent tester on and enter the following menus: Chassis / ABS/VSC/TRC / Utility / ECB (Electronically Controlled Brake system) Utility / Zero Down.

  1. Select "Next" and wait for 10 seconds.



    C232352E02

  1. After the booster pump has stopped, inspect that the fluid level is between the MAX and MIN lines. If necessary, refill the brake fluid to the MAX line.
    Text in Illustration 
    *1
    		MAX Line
    *2
    		MIN Line

    Brake fluid:
    SAE J1703 or FMVSS No. 116 DOT3



2. INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (for not Using the intelligent tester)


    C232352E03

  1. Inspect that the fluid level is above the MIN line with the power switch on (IG). If necessary, refill the brake fluid to the fluid level support line with the power switch on (IG).
    Text in Illustration 
    *1
    		Fluid Level Support Line

    Brake fluid:
    SAE J1703 or FMVSS No. 116 DOT3