SKID CONTROL BUZZER (for LHD) > INSTALLATION

for Preparation Click here

1. Connect the skid control buzzer connector.
   

2. Install the skid control buzzer assembly.
   

1. Check that the power switch is off.
   

2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
   

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
   

   NOTICE:

   When connecting any airbag connector, take care not to damage the airbag wire harness.

4. Push in the lock to install the airbag connector.
   

5. Temporarily install the lower No. 1 instrument panel airbag assembly with the 6 claws and 3 guides.
   

6. Install the 4 bolts.
   

   Torque:

   10 N*m{ 102 kgf*cm , 7 ft.*lbf }

   NOTICE:

   Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

1. Connect each connector.
   

2. Engage the clamp.
   

3. Engage the clip.
   

4. Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <E>.