Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER (for LHD)

SKID CONTROL BUZZER (for LHD) > INSPECTION

for Preparation Click here



1. INSPECT SKID CONTROL BUZZER ASSEMBLY


    C181788E13

  1. Make sure that there is no looseness at the locking part and the connecting part of the connector.

  1. Disconnect the skid control buzzer connector.

  1. Check both the connector case and the terminal for deformation and corrosion.

    OK:
    No deformation or corrosion.

  1. Connect a negative (-) lead from the battery to terminal 1 (BZ), and a positive (+) lead to terminal 2 (IG1) of the skid control buzzer, and then check that the buzzer sounds.

    OK:
    The skid control buzzer sounds.

    Text in Illustration 
    *a
    		Component without harness connected
    (Skid Control Buzzer)
    If the result is not as specified, replace the skid control buzzer.