SHIFT CONTROL ACTUATOR > INSTALLATION

for Preparation Click here

NOTICE:

It is not always necessary to replace or remove/install the shift control actuator seal at the same time when replacing the shift control actuator assembly.

HINT:

Remove/install the shift control actuator seal only if oil leaks from the shift control actuator seal or other faults are found when the shift control actuator assembly is removed.

1. Using SST and a hammer, tap in a new shift control actuator seal.
   

   SST

   09820-00031  
   

   Seal installation depth:

   8.5 to 9.8 mm (0.335 to 0.386 in.)
   

   Text in Illustration 

   *a	Seal installation depth

1. Install the shift control actuator assembly with 3 new shift control actuator bolts.
   

   Torque:

   9.5 N*m{ 97 kgf*cm , 84 in.*lbf }

2. Install 3 new shift control actuator bolt caps to the shift control actuator bolts.
   

   NOTICE:

   Push in each shift control actuator cap firmly until the claw of the shift control actuator bolt cap engages with the control actuator bolt.

3. Connect the connector to the shift control actuator assembly.