Home › Drivetrain › P410 HYBRID TRANSMISSION / TRANSAXLE › SHIFT CONTROL ACTUATOR

SHIFT CONTROL ACTUATOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY


    C209274

  1. Disconnect the connector from the shift control actuator assembly.



    C211698

  1. Remove the 3 shift control actuator bolts and shift control actuator assembly.

    HINT:
    1. Please refer to Service Bulletin for details on the removal procedure of the shift control actuator bolts.
    2. This actuator is a precision instrument. Do not strike it with a plastic hammer or the like during installation.
    3. This actuator detects its own position when the auxiliary battery is reconnected. Thus it does not require initialization.



3. REMOVE SHIFT CONTROL ACTUATOR SEAL

NOTICE:
It is not always necessary to replace or remove/install the shift control actuator seal at the same time when replacing the shift control actuator assembly.

HINT:
Remove/install the shift control actuator seal only if oil leaks from the shift control actuator seal or other faults are found when the shift control actuator assembly is removed.

  1. Using a screwdriver with its tip taped, remove the shift control actuator seal.

    NOTICE:
    When removing the shift control actuator seal, be sure not to damage the case or manual shaft with the screwdriver.