BRAKE BOOSTER PUMP > DISPOSAL

for Preparation Click here

1. Remove the accumulator from the brake booster pump assembly.
   

2. Secure the accumulator in a vise.
   

3. Using a hacksaw, make a cut in the side of the accumulator at location [A] to release the high-pressure gas.
   

   Point	Area
   A	25 mm (0.984 in.)
   B	60 mm (2.362 in.)

   CAUTION:

   Small pieces of metal may fly out when cutting into the accumulator. Put a piece of cloth over the hacksaw when cutting the accumulator. Cut the accumulator slowly so that the gas will be released gradually.

   HINT:

   The gas is colorless, odorless and non-poisonous.