Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU (for RHD)

HEADLIGHT LEVELING ECU (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY

  1. Engage the guide.

  1. Install the headlight leveling ECU assembly with the nut.

  1. Connect the connector.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

HINT:
Use the same procedure for the RH side and LH side .



3. INSTALL INSTRUMENT SIDE PANEL RH

  1. Connect the connector.



    B269870

  1. Engage the 4 guides, clip and 3 claws to install the instrument side panel RH.



4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B270533E01

  1. Align the alignment mark (light blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip RH.
    Text in Illustration 
    *a
    		Alignment Mark (Light blue)

    NOTICE:
    After installation, check that the corners fit correctly.



5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

  1. Connect each connector.

  1. Engage the clamp.

  1. Engage the 2 clips.

  1. Install the No. 1 instrument panel under cover sub-assembly with the screw <E>.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

  1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.



8. INSTALL DECK FLOOR BOX RH

  1. Engage the 6 guides.

  1. Install the deck floor box RH with the clip.



9. INSTALL REAR NO. 3 FLOOR BOARD

  1. Install the rear No. 3 floor board.



10. INSTALL REAR DECK FLOOR BOX

  1. Install the rear deck floor box.



11. INSTALL REAR NO. 2 FLOOR BOARD

  1. Install the rear No. 2 floor board.



12. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION
(Click here)


13. ADJUST HEADLIGHT AIMING
(Click here)