Home › Steering › STEERING COLUMN › STEERING HEATER SWITCH

STEERING HEATER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING HEATER SWITCH

  1. Engage the 2 claws to install the steering heater switch to the lower instrument panel finish panel sub-assembly.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

  1. Connect each connector.



    B263506

  1. Engage the 8 claws and clip to install the lower instrument panel finish panel sub-assembly.



3. INSTALL INSTRUMENT SIDE PANEL


    B263502

  1. Engage the 4 guides, clip and 3 claws to install the instrument side panel LH.



4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP


    B270535E01

  1. Align the alignment mark (orange) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
    Text in Illustration 
    *a
    		Alignment Mark (Orange)

    NOTICE:
    After installation, check that the corners fit correctly.