Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER MOTOR ASSEMBLY

FUEL LID OPENER MOTOR ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL LID WITH MOTOR LOCK ASSEMBLY


    B271907E01

  1. Apply auxiliary battery voltage to the motor terminals and check that the motor operates and the shaft moves in the open direction.

    OK:
    Measurement Condition
    		Specified Condition
    Auxiliary battery positive (+) → Terminal 2
    Auxiliary battery negative (-) → Terminal 1
    		Motor operates and shaft moves in open direction

    Text in Illustration 
    *a
    		Component without harness connected:
    (Fuel Lid with Motor Lock Assembly)
    *b
    		Open
    *c
    		Shaft Stroke

  1. Measure the shaft stroke.

    Standard:
    9.9 mm (0.390 in.) or more

    If the result is not as specified, replace the motor assembly.