Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER SWITCH

FUEL LID OPENER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FUEL LID OPENER SWITCH


    B271906E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    4 (B) - 1 (L)
    		Fuel lid opener switch pushed
    		Below 1 Ω
    4 (B) - 1 (L)
    		Fuel lid opener switch not pushed
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Fuel Lid Opener Switch)
    If the result is not as specified, replace the fuel lid opener switch.

  1. Check that the switch illuminates.

    1. Apply auxiliary battery voltage to the fuel lid opener switch and check that the switch illuminates.

      OK:
      Measurement Condition
      		Specified Condition
      Auxiliary battery positive (+) → terminal 3
      Auxiliary battery negative (-) → terminal 2
      		Illuminates

      If the result is not as specified, replace the bulb.