SUSPENSION & AXLE
AXLE
AXLE SYSTEM
FRONT AXLE HUB BOLT
FRONT AXLE HUB
STEERING KNUCKLE
REAR AXLE HUB BOLT
REAR AXLE HUB
SUSPENSION CONTROL
ADAPTIVE VARIABLE SUSPENSION SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- OPERATION CHECK
- TEST MODE PROCEDURE
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- C1715 When either of the following continues for 0.5 seconds or more:A signal of -9.8m/s2 to 9.8m/s2 or less is not...
- C1773 The fail flag signal is received from the steering control ECU for 5 seconds.
- C1716 When either of the following continues for 0.5 seconds or more:A signal of -9.8m/s2 to 9.8m/s2 or less is not...
- C1774 The terminal B or battery voltage is below 10 V or above 16 V for 0.5 seconds.
- C1717 When either of the following continues for 0.5 seconds or more:A signal of -9.8m/s2 to 9.8m/s2 or less is not...
- C1776 The speed sensor malfunction signal is received for 1 second or more.
- C1791 When either of the following continues for 0.5 seconds or more:A signal of -9.8m/s2 to 9.8m/s2 or less is not...
- C1777 Either the steering angle sensor DTC or steering angle sensor power source DTC is received for 5 seconds or...
- C1792 When either of the following continues for 0.5 seconds or more:A signal of -9.8m/s2 to 9.8m/s2 or less is not...
- C1787 There is no change in the absorber control switch signal when performing the Test Mode check.
- C1793 When either of the following continues for 0.5 seconds or more:A signal of -9.8m/s2 to 9.8m/s2 or less is not...
- U0100
- C1725 When either of the following is detected:An actuator open-circuit signal is detected for at least 1 second...
- U0101
- C1726 When either of the following is detected:An actuator open-circuit signal is detected for at least 1 second...
- U0122
- C1727 When either of the following is detected:An actuator open-circuit signal is detected for at least 1 second...
- U0126
- C1728 When either of the following is detected:An actuator open-circuit signal is detected for at least 1 second...
- U0130
- C1761 CAN communication resistor malfunction or internal absorber control ECU malfunction.
- U0132
- Absorber Control Indicator Light Remains On
- Absorber Control Indicator Light does not Come On
- TC and CG Terminal Circuit
- TS and CG Terminal Circuit
FRONT ACCELERATION SENSOR
REAR ACCELERATION SENSOR
ABSORBER CONTROL ECU
SUSPENSION
SUSPENSION SYSTEM
FRONT WHEEL ALIGNMENT
REAR WHEEL ALIGNMENT
FRONT SHOCK ABSORBER
FRONT SUSPENSION UPPER ARM
FRONT SUSPENSION LOWER ARM
FRONT LOWER BALL JOINT
FRONT STABILIZER BAR
REAR SHOCK ABSORBER
REAR NO. 1 UPPER CONTROL ARM
REAR NO. 2 UPPER CONTROL ARM
TOE CONTROL LINK
REAR SUSPENSION NO. 1 ARM
REAR SUSPENSION NO. 2 ARM
REAR STABILIZER BAR
TIRE AND WHEEL
TIRE AND WHEEL SYSTEM
TIRE PRESSURE WARNING SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- REGISTRATION
- INITIALIZATION
- TEST MODE PROCEDURE
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- C2111/11
- C2184/84
- C2112/12
- C2141/41
- C2113/13
- C2142/42
- C2114/14
- C2143/43
- C2121/21
- C2144/44
- C2122/22
- C2165/65
- C2123/23
- C2166/66
- C2124/24
- C2167/67
- C2131/31
- C2168/68
- C2132/32
- C2171/71
- C2133/33
- C2172/72
- C2134/34
- C2176/76
- C2181/81
- C2177/77
- C2182/82
- C2191/91
- C2183/83
- C2192/92
- Tire Pressure Warning Reset Switch Circuit
- Tire Pressure Warning Light Circuit
- Error in Present While Identifying Transmitter
- Error in Past When Identifying Transmitter
- ECU Power Source Circuit
- TC and CG Terminal Circuit