PARK / NEUTRAL POSITION SWITCH > INSTALLATION

1. INSTALL NEUTRAL START SWITCH ASSEMBLY

2. INSTALL ENGINE REAR MOUNTING MEMBER

3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. ADJUST SHIFT LEVER POSITION

6. INSPECT SHIFT LEVER POSITION

7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

8. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY

9. INSTALL FRONT EXHAUST PIPE ASSEMBLY

10. INSTALL ENGINE UNDER COVER AIR GUIDE BRACKET

11. ADD AUTOMATIC TRANSMISSION FLUID

12. INSTALL ENGINE UNDER COVER NO.2

13. CHECK FOR EXHAUST GAS LEAKS

14. PERFORM INITIALIZATION