AUTOMATIC TRANSMISSION ASSEMBLY > INSTALLATION

1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY

2. INSTALL TRANSMISSION OIL COOLER

3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH

4. INSTALL ENGINE MOUNTING INSULATOR REAR NO.1

5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

6. INSTALL WATER BY-PASS HOSE

7. INSTALL WIRE HARNESS

8. INSTALL CONNECTOR

9. INSTALL ENGINE REAR MOUNTING MEMBER

10. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

11. INSTALL EXHAUST PIPE NO.1 SUPPORT BRACKET SUB-ASSEMBLY

12. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT

13. INSTALL STARTER ASSEMBLY

14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

15. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

17. ADJUST SHIFT LEVER POSITION

18. INSPECT SHIFT LEVER POSITION

19. INSTALL FRONT EXHAUST PIPE ASSEMBLY

20. INSTALL ENGINE UNDER COVER AIR GUIDE BRACKET

21. ADD COOLANT

22. ADD AUTOMATIC TRANSMISSION FLUID

23. ADJUST COOLANT

24. CHECK FOR ENGINE COOLANT LEAKS

25. CHECK FOR EXHAUST GAS LEAKS

26. INSTALL ENGINE UNDER COVER NO.2

27. INSTALL ENGINE UNDER COVER

28. RESET MEMORY

29. PERFORM INITIALIZATION