AUTOMATIC TRANSMISSION ASSEMBLY > REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER

3. REMOVE ENGINE UNDER COVER NO.2

4. DRAIN COOLANT

5. DRAIN AUTOMATIC TRANSMISSION FLUID

6. REMOVE ENGINE UNDER COVER AIR GUIDE BRACKET

7. REMOVE FRONT EXHAUST PIPE ASSEMBLY

8. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY

9. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

10. REMOVE STARTER ASSEMBLY

11. REMOVE DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT

12. REMOVE EXHAUST PIPE NO.1 SUPPORT BRACKET SUB-ASSEMBLY

13. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

14. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

15. REMOVE ENGINE REAR MOUNTING MEMBER

16. SEPARATE CONNECTOR

17. SEPARATE WIRE HARNESS

18. SEPARATE WATER BY-PASS HOSE

19. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

20. REMOVE ENGINE MOUNTING INSULATOR REAR NO.1

21. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH

22. REMOVE TRANSMISSION OIL COOLER

23. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY

24. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY