REAR DRIVE SHAFT ASSEMBLY > INSTALLATION

1. INSTALL REAR DRIVE SHAFT ASSEMBLY

2. INSTALL UPPER CONTROL ARM ASSEMBLY REAR NO.2

3. TEMPORARILY TIGHTEN UPPER CONTROL ARM ASSEMBLY REAR NO.1

4. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

5. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

6. INSTALL REAR STABILIZER LINK ASSEMBLY

7. INSTALL REAR DISC

8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

9. INSTALL SPEED SENSOR REAR

10. INSTALL REAR AXLE SHAFT NUT

11. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3

12. STABILIZE SUSPENSION

13. FULLY TIGHTEN UPPER CONTROL ARM ASSEMBLY REAR NO.1

14. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

15. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

16. INSTALL REAR SUSPENTION MEMBER BRACE

17. INSTALL DIFFERENTIAL SUPPORT PROTECTOR NO.2

18. INSTALL REAR WHEEL

19. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

20. CHECK ABS SPEED SENSOR SIGNAL