PARK / NEUTRAL POSITION SWITCH > INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

2. INSTALL ENGINE REAR MOUNTING MEMBER

3. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. ADJUST SHIFT LEVER POSITION

6. INSPECT SHIFT LEVER POSITION

7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

8. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY

9. INSTALL FRONT EXHAUST PIPE ASSEMBLY

10. INSTALL ENGINE UNDER COVER AIR GUIDE BRACKET

11. INSTALL ENGINE UNDER COVER NO.2

12. PERFORM INITIALIZATION