ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

2. INSTALL INTAKE MANIFOLD

3. INSTALL INTAKE AIR SURGE TANK

4. CONNECT FUEL MAIN TUBE

5. CONNECT VENTILATION HOSE

6. CONNECT UNION TO CHECK VALVE HOSE

7. INSTALL ENGINE REAR COVER

8. CONNECT HEATER WATER INLET HOSE

9. CONNECT WATER BY-PASS HOSE

10. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

11. CONNECT NO. 2 VENTILATION HOSE

12. ADD ENGINE COOLANT

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

14. CHECK FOR ENGINE COOLANT LEAKS

15. CHECK FUNCTION OF THROTTLE BODY

16. INSTALL V-BANK COVER

17. INSTALL ENGINE ROOM SIDE COVER RH

18. INSTALL COOL AIR INTAKE DUCT SEAL

19. INSTALL ENGINE UNDER COVER

20. PERFORM INITIALIZATION

21. WARM UP ENGINE