REAR SHOCK ABSORBER > INSTALLATION

1. INSTALL REAR SHOCK ABSORBER WITH COIL SPRING

2. INSTALL ABSORBER CONTROL ACTUATOR (for AVS)

3. INSTALL REAR SHOCK ABSORBER CAP

4. TEMPORARILY TIGHTEN REAR SUSPENSION NO.2 ARM

5. STABILIZE SUSPENSION

6. FULLY TIGHTEN REAR SUSPENSION NO. 2 ARM

7. INSTALL REAR SUSPENSION MEMBER BRACE

8. INSTALL DIFFERENTIAL NO.2 SUPPORT PROTECTOR

9. INSTALL REAR TIRE

10. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER

11. INSTALL REAR FLOOR FINISH PLATE

12. INSTALL TOOL BOX

13. INSTALL TOOL BOX BOARD

14. INSTALL LUGGAGE COMPARTMENT TRIM SIDE COVER LH

15. INSTALL LUGGAGE COMPARTMENT TRIM SIDE COVER RH

16. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

18. INSPECT ADAPTIVE VARIABLE SUSPENSION SYSTEM

19. PERFORM INITIALIZATION

20. INSPECT AND ADJUST REAR WHEEL ALIGNMENT