LIGHTING SYSTEM > Turn Signal Light Circuit

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK OPERATION OF TURN SIGNAL LIGHT

PERFORM ACTIVE TEST BY INTELLIGENT TESTER

INSPECT FUSE (TURN-HAZ, LH-IG)

CHECK WIRE HARNESS (TURN SIGNAL FLASHER - BATTERY AND BODY GROUND)

CHECK WIRE HARNESS (TURN SIGNAL FLASHER - COWL SIDE JUNCTION BLOCK LH)

REPLACE TURN SIGNAL FLASHER

REPLACE FRONT TURN SIGNAL LIGHT BULB (TURN LH OR TURN RH)

CHECK WIRE HARNESS (TURN SIGNAL FLASHER - HEADLIGHT ASSEMBLY (TURN LH OR TURN RH) - BODY GROUND)

REPLACE TURN SIGNAL LIGHT BULB (FRONT SIDE LH OR FRONT SIDE RH)

CHECK WIRE HARNESS (TURN SIGNAL FLASHER - TURN SIGNAL LIGHT (FRONT SIDE LH OR FRONT SIDE RH) - BODY GROUND)

REPLACE REAR COMBINATION LIGHT BULB (TURN LH OR TURN RH)

CHECK WIRE HARNESS (TURN SIGNAL FLASHER - REAR COMBINATION LIGHT (TURN LH OR TURN RH) - BODY GROUND)