LIGHTING SYSTEM > Stop Light Circuit

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

READ VALUE OF INTELLIGENT TESTER

INSPECT FUSE (STOP SW)

INSPECT STOP LIGHT SWITCH

CHECK WIRE HARNESS (NO. 1 JUNCTON BLOCK - BATTERY)

PERFORM ACTIVE TEST BY INTELLIGENT TESTER

INSPECT FUSE (STOP LP L, STOP LP R)

CHECK WIRE HARNESS (NO. 1 JUNCTION BLOCK - BATTERY)

CHECK WIRE HARNESS (NO. 1 JUNCTION BLOCK - LIGHT (STOP LH OR STOP RH) - BODY GROUND)

REPLACE REAR COMBINATION LIGHT (STOP LH OR STOP RH)

REPLACE NOISE FILTER

REPLACE CENTER STOP LIGHT

CHECK WIRE HARNESS (NO. 1 JUNCTION BLOCK - NOISE FILTER)

CHECK WIRE HARNESS (NOISE FILTER - CENTER STOP LIGHT)

CHECK WIRE HARNESS (CENTER STOP LIGHT - BODY GROUND)