LIGHTING SYSTEM > Taillight Circuit

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK OPERATION OF FRONT LIGHT OR REAR LIGHT

PERFORM ACTIVE TEST BY INTELLIGENT TESTER

INSPECT FUSE (FR TAIL, FR CTRL-AM)

REPLACE CLEARANCE LIGHT BULB (LH OR RH)

CHECK WIRE HARNESS (ENGINE ROOM NO. 2 JUNCTION BLOCK - BATTERY)

CHECK WIRE HARNESS (ENGINE ROOM NO. 2 JUNCTION BLOCK - BODY GROUND)

PERFORM ACTIVE TEST BY INTELLIGENT TESTER

INSPECT FUSE (RR TAIL)

CHECK WIRE HARNESS (NO. 1 JUNCTION BLOCK - BATTERY)

CHECK WIRE HARNESS (NO. 1 JUNCTION BLOCK - LIGHT (TAIL INNER LH OR TAIL INNER RH) - BODY GROUND)

REPLACE REAR COMBINATION LIGHT (TAIL INNER LH OR TAIL INNER RH)

CHECK WIRE HARNESS (NO. 1 JUNCTION BLOCK - LIGHT (TAIL OUTER LH OR TAIL OUTER RH) - BODY GROUND)

REPLACE REAR COMBINATION LIGHT (TAIL OUTER LH OR TAIL OUTER RH)

CHECK WIRE HARNESS (NO. 1 JUNCTON BLOCK - LIGHT - BODY GROUND)

REPLACE LICENSE PLATE LIGHT