KNOCK SENSOR > INSTALLATION

1. INSTALL KNOCK SENSOR

2. INSTALL INTAKE MANIFOLD

3. INSTALL INTAKE AIR SURGE TANK

4. CONNECT FUEL MAIN TUBE

5. CONNECT NO. 1 VENTILATION HOSE

6. CONNECT UNION TO CHECK VALVE HOSE

7. CONNECT WATER BY-PASS HOSE

8. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

9. CONNECT NO. 2 VENTILATION HOSE

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. ADD ENGINE COOLANT

12. CHECK FOR ENGINE COOLANT LEAKAGE

13. CHECK FOR FUEL LEAKAGE

14. CHECK FOR ENGINE OIL LEAKS

15. INSTALL V-BANK COVER

16. INSTALL ENGINE ROOM SIDE COVER RH

17. REMOVE COOL AIR INTAKE DUCT SEAL

18. REMOVE ENGINE UNDER COVER

19. PERFORM INITIALIZATION

20. WARM UP ENGINE