FUEL PRESSURE SENSOR > INSTALLATION

1. INSTALL FUEL PRESSURE SENSOR

2. INSTALL NO. 1 FUEL PIPE

3. INSTALL INTAKE MANIFOLD

4. INSTALL INTAKE AIR SURGE TANK

5. CONNECT FUEL MAIN TUBE

6. CONNECT VENTILATION HOSE

7. CONNECT UNION TO CHECK VALVE HOSE

8. INSTALL ENGINE REAR COVER

9. CONNECT HEATER WATER INLET HOSE

10. CONNECT WATER BY-PASS HOSE

11. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

12. CONNECT NO. 2 VENTILATION HOSE

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

14. ADD ENGINE COOLANT

15. CHECK FOR ENGINE COOLANT LEAKAGE

16. CHECK FOR FUEL LEAKAGE

17. CHECK FOR OIL LEAKAGE

18. INSTALL V-BANK COVER

19. INSTALL ENGINE ROOM SIDE COVER RH

20. INSTALL COOL AIR INTAKE DUCT SEAL

21. INSTALL ENGINE UNDER COVER

22. PERFORM INITIALIZATION

23. WARM UP ENGINE