FUEL PRESSURE SENSOR > REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE COOL AIR INTAKE DUCT SEAL

4. REMOVE ENGINE UNDER COVER

5. DRAIN ENGINE COOLANT

6. REMOVE ENGINE ROOM SIDE COVER RH

7. REMOVE V-BANK COVER

8. DISCONNECT NO. 2 VENTILATION HOSE

9. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE ASSEMBLY

10. DISCONNECT WATER BY-PASS HOSE

11. DISCONNECT HEATER WATER INLET HOSE

12. REMOVE ENGINE REAR COVER

13. DISCONNECT UNION TO CHECK VALVE HOSE

14. DISCONNECT VENTILATION HOSE

15. REMOVE INTAKE AIR SURGE TANK

16. DISCONNECT FUEL MAIN TUBE

17. REMOVE INTAKE MANIFOLD

18. DISCONNECT NO. 1 FUEL PIPE

19. REMOVE FUEL PRESSURE SENSOR