HIGH PRESSURE SIDE FUEL PUMP > INSTALLATION

1. INSTALL HIGH PRESSURE SIDE FUEL PUMP

2. CONNECT NO. 2 FUEL PIPE

3. REMOVE FUEL PRESSURE PULSATION DAMPER

4. INSTALL NO. 1 FUEL PIPE

5. INSTALL INTAKE MANIFOLD

6. REMOVE INTAKE AIR SURGE TANK

7. CONNECT FUEL MAIN TUBE

8. CONNECT VENTILATION HOSE

9. CONNECT UNION TO CHECK VALVE HOSE

10. INSTALL ENGINE REAR COVER

11. CONNECT HEATER WATER INLET HOSE

12. CONNECT WATER BY-PASS HOSE

13. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

14. CONNECT NO. 2 VENTILATION HOSE

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

16. ADD ENGINE COOLANT

17. CHECK FOR ENGINE COOLANT LEAKAGE

18. CHECK FOR FUEL LEAKAGE

19. CHECK FOR ENGINE OIL LEAKS

20. INSTALL V-BANK COVER

21. INSTALL ENGINE ROOM SIDE COVER RH

22. INSTALL COOL AIR INTAKE DUCT SEAL

23. INSTALL ENGINE UNDER COVER

24. PERFORM INITIALIZATION

25. WARM UP ENGINE