STEERING COLUMN ASSEMBLY (for 3GR-FE) > INSTALLATION

1. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY NO.2

2. INSTALL STEERING COLUMN ASSEMBLY

3. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY NO.2

4. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY

5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

6. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

7. INSTALL TILT AND TELESCOPIC SWITCH

8. INSTALL STEERING COLUMN COVER

9. ADJUST SPIRAL CABLE SUB- ASSEMBLY

10. INSTALL STEERING WHEEL ASSEMBLY

11. INSPECT STEERING WHEEL CENTER POINT

12. INSTALL AIR DUCT NO.1

13. INSTALL INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1

14. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY NO.1

15. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

16. INSTALL INSTRUMENT SIDE PANEL LH

17. INSTALL FRONT DOOR OPENING TRIM COVER LH

18. INSTALL FRONT DOOR SCUFF PLATE LH

19. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

20. INSTALL CONSOLE UPPER PANEL SUB-ASSEMBLY

21. INSTALL CONSOLE UPPER PANEL GARNISH FRONT

22. INSPECT STEERING WHEEL PAD

23. INSTALL STEERING WHEEL PAD

24. INSTALL STEERING WHEEL COVER LOWER NO.3

25. INSTALL STEERING WHEEL COVER LOWER NO.2

26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

27. INSPECT SRS WARNING LIGHT

28. PERFORM INITIALIZATION