STEERING COLUMN ASSEMBLY (for 3GR-FSE) > REMOVAL

1. PRECAUTION

2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

4. REMOVE CONSOLE UPPER PANEL GARNISH FRONT

5. REMOVE CONSOLE UPPER PANEL SUB-ASSEMBLY

6. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

7. REMOVE FRONT DOOR SCUFF PLATE LH

8. REMOVE FRONT DOOR OPENING TRIM COVER LH

9. REMOVE INSTRUMENT SIDE PANEL LH

10. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

11. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY NO.1

12. REMOVE INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1

13. REMOVE STEERING WHEEL COVER LOWER NO.2

14. REMOVE STEERING WHEEL COVER LOWER NO.3

15. REMOVE STEERING WHEEL PAD

16. REMOVE STEERING WHEEL ASSEMBLY

17. REMOVE STEERING COLUMN COVER

18. REMOVE TILT AND TELESCOPIC SWITCH

19. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

20. REMOVE AIR DUCT NO.1

21. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY NO.2

22. REMOVE STEERING COLUMN ASSEMBLY

23. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY NO.2