WATER HOSE JOINT (for 3GR-FSE) > INSTALLATION

1. INSTALL WATER HOSE JOINT

2. CONNECT NO. 8 WATER BY-PASS HOSE

3. CONNECT NO. 7 WATER BY-PASS HOSE

4. INSTALL HEATER BLOWER WIRE

5. INSTALL WATER BY-PASS GLOW PLUG

6. CONNECT HEATER BLOWER WIRE

7. INSTALL ENGINE REAR COVER

8. REMOVE UNION TO CHECK VALVE HOSE (for RHD)

9. INSTALL V-BANK COVER SUB-ASSEMBLY

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. ADD ENGINE COOLANT

12. WARM UP ENGINE

13. CHECK FOR ENGINE COOLANT LEAKS

14. PERFORM INITIALIZATION