BRAKE MASTER CYLINDER (w/ VSC) > INSTALLATION

1. INSTALL BRAKE MASTER WITH PLATE CYLINDER SUB-ASSEMBLY

2. INSTALL ENGINE ROOM RELAY NO.3 BLOCK

3. FILL RESERVOIR WITH BRAKE FLUID

4. BLEED MASTER CYLINDER

5. BLEED BRAKE LINE

6. BLEED ABS AND TRACTION ACTUATOR ASSEMBLY

7. INSTALL FRONT WHEEL

8. CHECK FLUID LEVEL IN RESERVOIR

9. INSPECT BRAKE FLUID LEAKAGE

10. CLEAR DTC

11. CHECK VSC SENSOR SIGNAL

12. CHECK ACTUATOR WITH INTELLIGENT TESTER

13. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

14. INSTALL FRONT FENDER TO COWL SIDE SEAL LH

15. INSTALL FRONT FENDER TO COWL SIDE SEAL RH

16. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

17. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

18. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH

19. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB- ASSEMBLY RH

20. INSTALL ENGINE ROOM SIDE COVER RH

21. INSTALL ENGINE ROOM SIDE COVER LH

22. INSTALL COOL AIR INTAKE DUCT SEAL