BRAKE ACTUATOR (w/ ECB) > INSTALLATION

1. INSTALL BRAKE ACTUATOR WITH ACTUATOR BRACKET

2. INSTALL SKID CONTROL ECU ASSEMBLY

3. INSTALL ENGINE ROOM RELAY NO.3 BLOCK

4. INSTALL FRONT WHEEL LH

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. DISABLE BRAKE CONTROL

7. FILL RESERVOIR WITH BRAKE FLUID

8. BLEED BRAKE RESERVOIR TUBE NO.1 HOSE

9. BLEED MASTER CYLINDER

10. BLEED FRONT BRAKE SYSTEM

11. BLEED REAR BRAKE SYSTEM

12. PERFORM ACCUMULATOR ZERO DOWN

13. CHECK BRAKE FLUID LEVEL

14. INSPECT BRAKE FLUID LEAKAGE

15. CLEAR DTC

16. PERFORM INITIALIZATION

17. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

18. INSTALL FRONT FENDER TO COWL SIDE SEAL LH

19. INSTALL FRONT FENDER TO COWL SIDE SEAL RH

20. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

21. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

22. INSTALL ENGINE ROOM SIDE COVER LH

23. INSTALL ENGINE SIDE ROOM COVER RH

24. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH

25. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH

26. INSTALL COOL AIR INTAKE DUCT SEAL