HIGH MOUNTED STOP LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR

  1. Connect the connector.

  1. Attach the 2claws and install the sensor to the package tray trim center bracket.



2. INSTALL HIGH MOUNTED STOP LIGHT ASSEMBLY


E110961E01

  1. Connect the connector.

  1. Attach the 2claws and install the stop light to the package tray trim center bracket.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.