HIGH MOUNTED STOP LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY


E110961E01

  1. Detach the 2claws and remove the stop light from the package tray trim center bracket.

  1. Disconnect the connector.



3. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


E109381E01

  1. Disconnect the connector.

  1. Detach the 2 claws and remove the sensor from the high mounted stop lamp base.