HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE NO. 2 STEERING WHEEL COVER LOWER


    C107319

  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



4. REMOVE NO. 3 STEERING WHEEL COVER LOWER


    C107318

  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



5. REMOVE STEERING WHEEL PAD


    C106869E01

  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    C106868

  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



6. REMOVE STEERING WHEEL ASSEMBLY

  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and main shaft assembly.



    C105542E01

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05011)



7. REMOVE STEERING COLUMN COVER


    C105543E01

  1. Remove the 3 screws.

  1. Disengage the 2 claws to remove the steering column cover lower.

    NOTICE:
    Do not damage the tilt and telescopic switch.



    C105544E01

  1. Disengage the 4 clips to separate the steering column cover upper.

  1. Disengage the claw to remove the steering column cover upper.



8. REMOVE SPIRAL CABLE SUB-ASSEMBLY W/ STEERING SENSOR


    C110477E01

  1. Disconnect the connectors from the spiral cable with steering sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Disengage the 3 claws and remove the spiral cable with steering sensor.



9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


B107382E01

  1. Disconnect the connector.

  1. Detach the claw and remove the wiper switch.

    NOTICE:
    If the claw is pushed with excessive force, it may break.



10. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


B109940E01

  1. Disconnect the connector.



    B109941E01

  1. Detach the clamp from the dimmer switch as shown in the illustration.

  1. Detach the claw and remove the dimmer switch as shown in the illustration.