TURN SIGNAL LIGHT SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here

1. Disconnect the L25 connector.
   

2. Measure the voltage of the wire harness side connector.
   

   Standard voltage:

   Tester Connection	Condition	Specified Condition
   L25-1 (IG) - Body ground	Engine switch off	Below 1 V
   L25-1 (IG) - Body ground	Engine switch on (IG)	10 to 14 V
   L25-4 (B) - Body ground	Always	10 to 14 V
   L25-7 (E) - Body ground	Always	Below 1 V

3. Reconnect the connector.
   

4. Measure the voltage of the connector.
   

   Standard voltage:

   Tester Connection	Condition	Specified Condition
   L25-2 (LR) - Body ground	Hazard warning switch OFF	Below 1 V
   L25-2 (LR) - Body ground	Hazard warning switch ON	10 to 14 V (60 to 120 times per minute)
   L25-2 (LR) - Body ground	Engine switch on (IG) and turn signal switch (right turn) OFF	Below 1 V
   L25-2 (LR) - Body ground	Engine switch on (IG) and turn signal switch (right turn) ON	10 to 14 V (60 to 120 times per minute)
   L25-3 (LL) - Body ground	Hazard warning switch OFF	Below 1 V
   L25-3 (LL) - Body ground	Hazard warning switch ON	10 to 14 V (60 to 120 times per minute)
   L25-3 (LL) - Body ground	Engine switch on (IG) and turn signal switch (left turn) OFF	Below 1 V
   L25-3 (LL) - Body ground	Engine switch on (IG) and turn signal switch (left turn) ON	10 to 14 V (60 to 120 times per minute)
   L25-5 (EL) - Body ground	Engine switch on (IG) and turn signal switch (left turn) OFF	10 to 14 V
   L25-5 (EL) - Body ground	Engine switch on (IG) and turn signal switch (left turn) ON	Below 1 V
   L25-6 (ER) - Body ground	Engine switch on (IG) and turn signal switch (right turn) OFF	10 to 14 V
   L25-6 (ER) - Body ground	Engine switch on (IG) and turn signal switch (right turn) ON	Below 1 V
   L25-8 (HAZ) - Body ground	Hazard warning switch OFF	10 to 14 V
   L25-8 (HAZ) - Body ground	Hazard warning switch ON	Below 1 V

   If the result is not as specified, replace the flasher assembly.