REAR PROPELLER SHAFT ASSEMBLY (for 3UZ-FE) > REASSEMBLY

for Preparation Click here



1. INSTALL CENTER SUPPORT BEARING ASSEMBLY NO.1

NOTICE:
Be careful not to grip the propeller shaft tube too tightly in a vise as this may cause deformation.



    C109604E01

  1. Using SST and a press, install a new dust deflector No.1.

    SST
    09506-35010  
    09316-60011   (09316-00011)

    NOTICE:
    Be careful not to damage the dust deflector.



    C109605E01

  1. Using SST and a press, install the center support bearing assembly No.1.

    SST
    09330-50010  

    NOTICE:
    Be sure to install the bearing in the correct direction.



    C109606E01

  1. Using SST and a press, insert a new dust deflector until it almost touches the rubber of the center support bearing assembly No.1.

    SST
    09608-00071  
    09608-06041  

    NOTICE:
    Be careful not to damage the dust deflector No.2.



    C109607E01

  1. Using SST and a press, install a new dust deflector No.2.

    SST
    09330-50010  



    C109601

  1. Using a snap ring expander, install a new snap ring.



2. INSTALL PROPELLER INTERMEDIATE SHAFT


    C109600E01

  1. Install the dust boot.

    NOTICE:
    Assemble propeller intermediate shaft assembly after wrapping vinyl tape around the spline so that it will not damage the boot.

  1. Apply grease to the spline.

    Grease:
    Molybdenum disulphide lithium base, NLGI No.2

  1. Align the matchmarks and assemble the intermediate shaft and propeller shaft.



    C109608E01

  1. Cover the adjusting nut with the dust boot.

    NOTICE:
    The directions of the intermediate shaft companion flange and the propeller shaft companion flange should differ by 180°.

  1. Fully tighten the adjusting nut by hand.