FRONT BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BUMPER SIDE RETAINER LH


B100623E06

  1. Attach the 2 claws to install the screw and retainer.



2. INSTALL FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedures described for the LH side.



3. INSTALL FRONT BUMPER REINFORCEMENT


B110484E02

  1. Install the reinforcement with the bolts.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

  1. Install the cooler thermistor to the reinforcement.



4. INSTALL FRONT BUMPER ENERGY ABSORBER


B109983

  1. Install the energy absorber to the reinforcement.



5. INSTALL RADIATOR SUPPORT OPENING COVER


B107497E02

  1. Install the cover with the 4 clips.



6. INSTALL FRONT BUMPER COVER

  1. Connect the ultrasonic sensor connector.



    B107496E02

  1. Attach the 3 claws on the LH side.

  1. Attach the 3 claws on the RH side.



    B109982

  1. Install the bumper cover with the 2 clips, 6 screws and 5 bolts.



7. INSTALL RADIATOR GRILLE GARNISH

  1. Attach the 2 claws to install the 2 garnishes.



8. INSTALL FRONT FENDER LINER LH


    B106148

  1. Install the fender liner with the 2 clips.



9. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



10. INSTALL ENGINE UNDER COVER


B107493

  1. Install the under cover with the 3 clips and 10 screws.



11. INSTALL COOL AIR INTAKE DUCT SEAL


B106147

  1. Install the duct seal with the 7 clips.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


13. PERFORM INITIALIZATION

  1. Perform initialization (Click here ).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



14. CHECK SRS WARNING LIGHT

  1. Check the SRS warning light (Click here).