FRONT DOOR BELT MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY


B106162E12

  1. Attach the 7 claws to install the belt moulding.



2. INSTALL FRONT DOOR GLASS WEATHERSTRIP INNER


B106670


3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


    E107990E01

  1. Install the mirror with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Attach the clip.

  1. Connect the connector.



4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


B110182

  1. Connect the 2 cables to the inside handle as shown in the illustration.



    B110168E04

  1. Install the weatherstrip to the trim by attaching the 4 clips labeled A.

  1. Attach the 6 clips labeled B and 3 new clips labeled C to install the trim together with the weatherstrip.

  1. Install the 2 screws.



    B109742E02

  1. Connect the connector.

  1. Attach the 2 claws to install the trim lower cover.



5. INSTALL FRONT DOOR TRIM COVER LOWER


B110182

  1. Connect the 2 cables to the inside handle as shown in the illustration.



    B110168E04

  1. Install the weatherstrip to the trim by attaching the 4 clips labeled A.

  1. Attach the 6 clips labeled B and 3 new clips labeled C to install the trim together with the weatherstrip.

  1. Install the 2 screws.



    B109742E02

  1. Connect the connector.

  1. Attach the 2 claws to install the trim lower cover.



6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


B106665E05

  1. Attach the 3 claws to install the bezel plug.