REAR DOOR BELT MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY


B106803E05

  1. Attach the 6 claws to install the belt moulding.



2. INSTALL REAR DOOR GLASS WEATHERSTRIP INNER


B107102


3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


B110182

  1. Connect the 2 cables to the inside handle.



    B107096E04

  1. Install the weathrstrip to the trim by attaching the 4 clips labeled A.

  1. Attach the 4 clips labeled B and 2 new clips labeled C to install the trim together with the weatherstrip.

  1. Install the 2 screws.



    B109741E01

  1. Attach the 2 claws to install the trim lower cover.



4. INSTALL REAR DOOR TRIM COVER LOWER


B110182

  1. Connect the 2 cables to the inside handle.



    B107096E04

  1. Install the weathrstrip to the trim by attaching the 4 clips labeled A.

  1. Attach the 4 clips labeled B and 2 new clips labeled C to install the trim together with the weatherstrip.

  1. Install the 2 screws.



    B109741E01

  1. Attach the 2 claws to install the trim lower cover.



5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG


B106665E04

  1. Attach the 3 claws to install the bezel plug.