REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


B106665E03

  1. Using a screwdriver, detach the 3 claws and remove the bezel plug.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE REAR DOOR TRIM COVER LOWER


B109741E02

  1. Detach the 2 claws and trim lower cover.



    B107096E01

  1. Remove the 2 screws.

  1. Detach the 6 clips labeled B, and remove the trim together with the weatherstrip.

  1. Detach the 4 clips labeled A to separate the weatherstrip.



    B110164

  1. Disconnect the 2 cables from the inside handle.

  1. Disconnect the connectors and remove the trim board.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


B109741E02

  1. Detach the 2 claws and trim lower cover.



    B107096E01

  1. Remove the 2 screws.

  1. Detach the 6 clips labeled B, and remove the trim together with the weatherstrip.

  1. Detach the 4 clips labeled A to separate the weatherstrip.



    B110164

  1. Disconnect the 2 cables from the inside handle.

  1. Disconnect the connectors and remove the trim board.



4. REMOVE REAR DOOR GLASS WEATHERSTRIP INNER


B107102

  1. Remove the weatherstrip inner by pulling it upward.



5. REMOVE REAR DOOR BELT MOULDING ASSEMBLY

  1. Put protective tape under the belt moulding.



    B106803E01

  1. Using a moulding remover, detach the 6 claws and remove the belt moulding.