ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here


Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Clip
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body and clip excessively.

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. When replacing the clip, heat the vehicle body and clip using a heat light.



1. REMOVE ROOF DRIP SIDE FINISH MOULDING


B106812E03

  1. Put protective tape around the moulding.

  1. Using a moulding remover, detach the 16 clips and remove the moulding.

    NOTICE:
    1. Do not remove the clips from the vehicle body.
    2. If the clips are damaged or removed accidentally, replace them.