AUDIO AND VISUAL SYSTEM > CD Sound Skips

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CD
I100151
  1. Check the CD.

    OK:
    The CD is clean.

    HINT:
    If dirt is on the CD surface, wipe it with a soft cloth from inside to outside in a radial direction.

    NOTICE:
    Do not use conventional record cleaner or anti-static preservative.



NG
CLEAN CD
OK


2.CHECK CD
I100152
  1. Check that the CD is not deformed or cracked.

    OK:
    No deformations or cracks appear on the CD.



NG
CD IS FAULTY
OK


3.CHECK OPERATION USING ANOTHER CD
  1. Check using another CD.

    1. Check if the problem recurs using another CD.

      OK:
      The problem does not occur.



NG
CD IS FAULTY
OK


4.CHECK RADIO RECEIVER ASSEMBLY
  1. Check the radio receiver assembly installation condition.

    1. Check that the radio receiver assembly is properly installed.

      OK:
      Radio receiver assembly is properly installed.



NG
REINSTALL RADIO RECEIVER ASSEMBLY PROPERLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE