AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


WIRING DIAGRAM


E110164E01


INSPECTION PROCEDURE

1.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY


    E108083E03

  1. Disconnect the V29 and V31 stereo component amplifier connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    V31-16 (GND) - Body ground
    		Always
    		Below 1 Ω
    V31-15 (GND2) - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    V31-1 (+B) - Body ground
    		Always
    		10 to 14 V
    V31-10 (+B2) - Body ground
    		Always
    		10 to 14 V
    V29-12 (ACC) - Body ground
    		Engine switch on (ACC)
    		10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE