PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER NO.2

  1. Remove the 4 screws, 2 grommets, 2 spacers and under cover.



3. REMOVE ENGINE UNDER COVER AIR GUIDE BRACKET


    C107691

  1. Remove the 2 bolts and engine under cover air guide bracket.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


5. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(Click here)


6. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    C110474

  1. Remove the nut and separate the floor shift gear shifting rod sub-assembly.



7. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY


    C104744

  1. Support the automatic transmission assembly with a transmission jack.



8. SEPARATE ENGINE REAR MOUNTING MEMBER


    C104745

  1. Remove the 4 bolts, and separate the engine rear mounting member from the body.



    C104753

  1. Remove the 4 nuts and engine rear mounting member from the automatic transmission assembly.



9. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C108489E01

  1. Disconnect the park/neutral position switch connector.



    C108490E01

  1. Remove the nut and transmission control shaft lever RH.



    C104746

  1. Using a screwdriver, pry out the lock washer.

  1. Remove the lock nut and lock washer.



    C080256

  1. Remove the bolt and park/neutral position switch.