VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
When working with FIPG material, perform the following:
  1. Using a gasket scraper, remove all the old FIPG material from the gasket surfaces.
  2. Thoroughly clean all components to remove any loose material.
  3. Clean both sealing surfaces with a non-residue solvent.
  4. Apply FIPG in a continuous line (width approximately 1 mm (0.04 in.)) along the sealing surface.
  5. Parts must be assembled within 10 minutes of application. Otherwise, the FIPG material must be removed and reapplied.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER NO.2

  1. Remove the 4 screws, 2 grommets, 2 spacers and under cover.



3. DRAIN AUTOMATIC TRANSMISSION FLUID

  1. Remove the drain plug and gasket, drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



4. REMOVE EXHAUST PIPE NO.1 SUPPORT BRACKET SUB-ASSEMBLY


    C108503E01

  1. Remove the 2 bolts and exhaust pipe No.1 support bracket sub-assembly from the automatic transmission assembly.



5. REMOVE ENGINE UNDER COVER AIR GUIDE BRACKET


    C107691

  1. Remove the 2 bolts and engine under cover air guide bracket.



6. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

NOTICE:
Some fluid will remain in the oil pan.



    C109360

  1. Remove the 20 bolts, oil pan and gasket.



    C111035E01

  1. Remove the 3 magnets from the oil pan.

  1. Examine particles in the pan.

    1. Collect any steel chips with the removed magnets.
      Carefully look at the foreign objects and particles in the pan and on the magnets to guess at the type of wear which might be found in the transmission.
      Steel (magnetic)... bearing, gear and clutch plate wear
      Brass (non-magnetic)... bushing wear



7. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    C106929

  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid will come out of the oil strainer.



    C108414E01

  1. Remove the O-ring from the oil strainer.



8. DISCONNECT TRANSMISSION WIRE


    C106930

  1. Remove the bolt and lock plate, and separate the ATF temperature sensor.

  1. Remove the 2 bolts and disconnect the 2 clamps.

  1. Disconnect the 9 connectors from the solenoid valves.



9. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    C106932

  1. Remove the 19 bolts and valve body.



    C109330E01

  1. Separate the lever pin from the manual valve.



    C108494E02

  1. Remove the check ball body and spring.

    NOTICE:
    Do not drop the check ball body and spring.