EXTENSION HOUSING REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL

  1. Coat the lip of a new oil seal with MP grease.



    C108486E01

  1. Using SST and a hammer, drive in a new oil seal.

    SST
    09316-60011   (09316-00011)

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap the oil seal at an angle.



2. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(Click here)


3. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. ADD AUTOMATIC TRANSMISSION FLUID
(Click here)


6. CHECK FOR EXHAUST GAS LEAKS


7. INSTALL ENGINE UNDER COVER NO.2

  1. Install the under cover with the 4 screws, 2 grommets and 2 spacers.



8. PERFORM INITIALIZATION
(Click here)